GData EncoderLED-u

EncoderLED-u module is a all-in-one timing path controller.

Encoder controller

• standard Encoder quadrature decoding.
• Provides 5 V power for the encoder sensor.
• Encoder emulator and counter for testing and experimentation.
• Trigger generator for synchronization and emulation.
  The trigger signal is routed to the internal bus and to the BNC connector for external synchronization.
• TrigOut
  Isolated trigger output signal.
  5 V TTL level, 1 µs pulse duration (programmable).

Encoder emulator

By providing emulated encoder signals, printing simulation can be performed very easily.

Trigger Generator

• frequency : 1 Hz ~ 100 kHz
• count : 67,108,863 max
• trigger out mux : trigger generator output, position encoder 4x signal, position encoder signal R, position encoder signal A
• electrically isolated trigger out signal.

LED strobo light controller

• Independent dual-channel output.
• Supports driving 7 W LEDs.
• Delay time and pulse duration can be configured.
  Clock resolution : 10 ns
  Duration time : > 100 ns
  Supports one-shot and two-shot modes.
• Synchronized by the trigger signal (trigOut).
• Terminal block connector : 5.08 mm pitch
  OQ0454510000G
  
  a0 : anode channel 0, c0 : cathode channel 0
  a1 : anode channel 1, c1 : cathode channel 1
  
  The cathode must not be connected to GND.

IP address setting

IP address = ConRTL Base Address (DIP switch) + GPCon2 Address(Rotary DIP switch).
For example, given Base Address = 192.168.0.100, the IP address becomes 192.168.0.102 when the rotary DIP switch value of GPCon2 is 2.